Project

General

Profile

Forums » GOautodial Help »

Hardware

Added by Greg Hitchcock over 10 years ago

Hi All,
I am trying to setup a test box for a possible GoAutoDial deployment. We are currently using an outdated (EOL) NEC IPK system that is no longer supported and I would like to test and see if this solution will work for us.

Currently, I have goautodial installed on a Dell Optiplex 755 running a Pentium dual core processor. Obviously, I will need to purchase a PRI card and a couple of phones to test with but my question is:

Will the Digium PRI card (PCI express card) mount up in the above mentioned PC (Dell), and then be connected to a VOIP compatible switch or will I need additional hardware to make this system work? Like switchvox etc...

I guess I am a bit lost as to how all of the pieces will fit together.

Please advise...

Thanks,
Greg


Replies (1)

RE: Hardware - Added by striker 247 over 10 years ago

Hi greg

what kind of trunk you are going to use to dial out via Goautodial?

if you are using PRI/ISDN or analog trunks(FXO) you need a digium cards

if you are using Just VOIP/SIP trunk to dialout then no need of digium cards,
just you need a good bandwidth for the goautodial server..
goautodial same like switchvox using Asterisk as a telephony server ,in which you can configure the voip trunks.

you can use Free softphones like xlite/zoiper or any ipphones (digium, grandstream, yealink)

Dell Optiplex 755 seems it has low profile pci slot, so you need order digium with low profile bracket...

br
striker
www.striker24x7.blogspot.com

    (1-1/1)     Go to top